Skip to Content Black Deal: up to 400 € off our Evolve skateboards, until 30 November. Black Deal: up to 400 € off our Evolve skateboards, until 30 November.See the deals
January 3, 2025 by
Installation Tutorial

How to Install a Protection Kit on Your Evolve Electric Skateboard

This article walks you through installing a protection kit on your Evolve electric skateboard, covering the Diablo, Hadean, and GTR models.

This article walks you through installing a protection kit on your Evolve electric skateboard, covering the Diablo, Hadean, and GTR models.

The kit installation process is the same for both the all-terrain (electric mountainboard) and street (electric longboard) versions.

This protection kit does double duty: it shields your motors from impacts and extends the life of your electric skateboard. Here’s how to get it installed correctly.

  • Y-Tool (comes with your skateboard)
  • 1/8 Allen key (included with your Y-Tool)
  • Medium-strength threadlocker (we use Loctite 243, but any medium-strength threadlocker will work)
1

Check the kit contents: You should have two protection kit brackets (marked L for left and R for right), three protection bars, and ten screws (four short, six long).

2

To keep things clear during installation, separate the short screws from the long ones.

3

Remove the wheel: Flip your board onto its side, then use the Y-Tool to take off one of the wheels.

4

Remove the drive belt cover: Grab your 1/8 Allen key to remove the drive belt cover, the drive belt, and the gear.

5

Identify the brackets: The brackets are marked L (left) and R (right) to indicate their respective positions.

6

Apply threadlocker: Put a small amount of threadlocker on the screw threads that will go into the protection kit bars.

7

Attach the brackets: Use two short screws to secure the protection kit bracket on the side where the wheel is still on.

8

Reinstall the wheel: Put the nut back on the wheel axle. This helps balance the board when you flip it over.

9

Repeat the previous steps: Remove the wheel, drive belt cover, drive belt, and gear, then install the protection kit bracket on the other side.

10

Align the bars: Slide each bar into place, lining it up with the bracket hole. Start with the bar closest to the axle.

11

Apply threadlocker: Before installing each long screw, apply a small amount of threadlocker to it.

12

Secure the bars: Tighten the screws firmly to hold the bars in place. Then, screw in the bars on the other side.

13

Retighten the brackets: If you loosened the brackets to make installing the bars easier, make sure to tighten them down firmly now.

14

Reassemble the components: Put the gear, drive belt, drive belt cover, and wheel back on. Tighten all components securely for a safe setup.

Reassemble the components: Put the gear, drive belt, drive belt cover, and wheel back on. Tighten all components securely for a safe setup.

Our picks for this article

How to Replace Your GTR Electric Longboard Battery | Step-by-Step Guide
Learn how to easily replace your GTR electric longboard battery. Practical guide to optimize range, performance, and safety. Follow our simple steps now!
Evolve Europe
4.8/5
★★★★★
271 verified reviews